Draining Fuel (Through The Fuel Filler Hose)

WARNING: This page is about a different car, the 2010 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Place "NO OPEN FLAMES" signs near the working area.

CAUTION:

Be careful not to spill fuel.
Fuel may remain in the fuel filler pipe. Draining the fuel from the fuel filler pipe through the fill opening using the gasoline proof pump and the gasoline proof hose (ø10 or less) before the operation.

Lift up the vehicle.
Remove the rear exhaust pipe and muffler. Ref. to REMOVAL , Rear Exhaust Pipe. Ref. to REMOVAL , Muffler.
Remove the rear sub frame. Ref. to REMOVAL , Rear Sub Frame.
Open the fuel filler lid and remove the fuel filler cap.
Drain the fuel from the fuel filler pipe through the filler opening using the gasoline proof pump and the gasoline proof hose (ø10 or less).
Disconnect the fuel filler hose from the fuel filler pipe assembly.
CAUTION:
- Be careful not to spill fuel.
- Catch the fuel from hoses using a container or cloth.
  
  Fig 1: Locating Fuel Filler Hose From Fuel Filler Pipe Assembly
  Courtesy of SUBARU OF AMERICA, INC.
Set the container under the vehicle and insert the gasoline proof hose (ø10 or less) into the fuel filler hose to drain the fuel.
CAUTION: Be careful not to spill fuel.
Install the related parts in the reverse order after draining the fuel.
Tightening torque: 2.5 N.m (0.3 kgf-m, 1.8 ft-lb)