LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Outback Limited >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrumentation System & Driver Information Center - Instrumentation/Driver Info >> Combination Meter System >> Inspection >> Symptom Chart

Symptom Chart

CAUTION: When measuring the voltage and resistance of each control module or sensor, use a tapered pin with a diameter of less than 0.64 mm (0.03 in) in order to avoid poor contact. Do not insert the pin more than 2 mm (0.08 in).
SYMPTOM CHART

Symptoms Repair order Note
Combination meter assembly does not operate.
  1. Power supply
  2. Ground circuit
  3. Combination meter
 Ref. to CHECK POWER SUPPLY AND GROUND CIRCUIT , INSPECTION, Combination Meter System.
Speedometer does not operate.
  1. VDC C/M
  2. Harness
  3. Combination meter
 Ref. to CHECK VDC CONTROL MODULE , INSPECTION, Combination Meter System.
Tachometer does not operate.
  1. ECM
  2. Harness
  3. Combination meter
 Ref. to CHECK ENGINE CONTROL MODULE (ECM) , INSPECTION, Combination Meter System.
Fuel gauge does not operate.
  1. Communication circuit
  2. Harness
  3. Body integrated unit
  4. Fuel level sensor
  5. Combination meter
 Ref. to CHECK FUEL LEVEL SENSOR , INSPECTION, Combination Meter System.
ECO gauge does not operate.
  1. Communication circuit
  2. Combination meter
 Ref. to CHECK ECO GAUGE , INSPECTION, Combination Meter System.
NOTE: The ECO gauge does not operate unless the vehicle is driven at least 1 km after the trip meter is reset.
Warning buzzer for key left in ignition does not beep.
  1. Communication circuit
  2. Combination meter
 Ref. to CHECK WARNING BUZZER FOR KEY LEFT IN IGNITION. , INSPECTION, Combination Meter System.
scientia non olet · About LEMON Manuals