Check ECO Gauge

SYMPTOM CHART

Step	Check	Yes	No
1 CHECK DIAGNOSTIC TROUBLE CODE (DTC). Prepare the Subaru Select Monitor kit. Turn the ignition switch to ON (engine OFF) and run the "PC application for Subaru Select Monitor". On «System Selection Menu» display, select {Integ. unit mode}. Select the {Diagnostic Code(s) Display}.	Is a DTC of high-speed CAN detected?	Perform the diagnosis according to DTC. Ref. to LIST , List of Diagnostic Trouble Code (DTC).	Go to step 2 .
2 CHECK ECO GAUGE. Perform the self-diagnosis of combination meter. Ref. to SELF-DIAGNOSIS DISPLAY MODE , OPERATION, Combination Meter System.	Does ECO gauge operate properly?	Check the connection status of the harness and connector that may have a temporary poor contact.	Replace the meter case assembly. Ref. to COMBINATION METER .