Section 8 (Engine Intake System - Intake (Induction) (H4DOTC - 2.5L DOHC Turbo)): Turbocharger: Assembly

WARNING: This page is about a different variant/trim than selected.

Install the exhaust stay to the turbocharger.
Tightening torque:

6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

Fig 1: Locating Exhaust Stay And Turbocharger
Courtesy of SUBARU OF AMERICA, INC.
Install the exhaust cover to the turbocharger.
Tightening torque:

6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

Fig 2: Locating Exhaust Cover And Turbocharger
Courtesy of SUBARU OF AMERICA, INC.
Install the water pipe connector to the turbocharger.
NOTE: Use a new gasket.

Tightening torque:

36.5 N.m (3.7 kgf-m, 26.9 ft-lb)

Fig 3: Locating Water Pipe Connector And Turbocharger
Courtesy of SUBARU OF AMERICA, INC.
Install the water pipe to the turbocharger.
NOTE: Use a new gasket.

Tightening torque:

31.5 N.m (3.2 kgf-m, 23.2 ft-lb)

Fig 4: Locating Water Pipe And Turbocharger
Courtesy of SUBARU OF AMERICA, INC.
Install the oil inlet pipe to the turbocharger.
NOTE: Use a new gasket.

Tightening torque:

T1: 6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

T2: 16 N.m (1.6 kgf-m, 11.8 ft-lb)

Fig 5: Identifying Oil Inlet Pipe And Turbocharger
Courtesy of SUBARU OF AMERICA, INC.