LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Legacy Premium, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Fuel Injection System - Fuel Injection (Fuel Systems) (H6DO - 3.6L DOHC)) >> Knock Sensor >> Installation

Knock Sensor: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the knock sensor to the cylinder block.

    Tightening torque: 

    25 N.m (2.5 kgf-m, 18.4 ft-lb) 

    NOTE: For the knock sensor installation angle, refer to the figure below.
    Fig 1: Identifying Knock Sensor Installation Angle
    G06651251Courtesy of SUBARU OF AMERICA, INC.
  2. Connect the knock sensor connector.
  3. Install the intake manifold. Ref. to INSTALLATION , Intake Manifold.
  4. Connect the ground cable to battery.
  5. Install the collector cover.
scientia non olet · About LEMON Manuals