LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Legacy Premium, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Fuel Injection System - Fuel Injection (Fuel Systems) (H6DO - 3.6L DOHC)) >> Fuel Injector >> Removal >> RH Side

RH Side

WARNING: This page is about a different variant/trim than selected.
  1. Remove the collector cover.
    NOTE: Follow these procedures for removal of the collector cover.
    1. Lift up the rear side holding two positions (A).
    2. Lift up the front side holding two positions (B) while moving it in the forward direction of the vehicle.
      Fig 1: Locating Front And Rear Side Holding Position
      G06651504Courtesy of SUBARU OF AMERICA, INC.
  2. Release the fuel pressure. Ref. to RELEASING OF FUEL PRESSURE , PROCEDURE, Fuel.
  3. Disconnect the ground cable from battery.
  4. Open the fuel filler lid and remove the fuel filler cap.
  5. Remove the air cleaner case and air intake boot assembly. Ref. to REMOVAL , Air Cleaner Case. Ref. to REMOVAL , Air Intake Boot.
  6. Remove the fuel pipe protector RH.
    Fig 2: Locating Fuel Pipe Protector RH Bolts
    G05018455Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect the connector from fuel injector.
  8. Remove the engine harness from the fuel injector pipe RH.
  9. Remove the bolt which holds fuel injector pipe onto cylinder head.
    Fig 3: Locating Fuel Injector Pipe Bolts
    G05667595Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the fuel injector while lifting up the fuel injector pipe.
scientia non olet · About LEMON Manuals