LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Legacy Premium, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Fuel Injection System - Fuel Injection (Fuel Systems) (H6DO - 3.6L DOHC)) >> EGR Valve >> Removal

EGR Valve: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the collector cover.
    NOTE: Follow these procedures for removal of the collector cover.
    1. Lift up the rear side holding two positions (A).
    2. Lift up the front side holding two positions (B) while moving it in the forward direction of the vehicle.
      Fig 1: Locating Front And Rear Side Holding Position
      G06651504Courtesy of SUBARU OF AMERICA, INC.
  2. Disconnect the ground cable from battery.
  3. Remove the air intake boot assembly. Ref. to REMOVAL , Air Intake Boot.
  4. Remove the starter. Ref. to REMOVAL , Starter.
  5. Remove the EGR pipe from EGR valve and cylinder head.
  6. Remove the EGR valve from intake manifold.
    Fig 2: Exploded View Of EGR Valve
    G05665298Courtesy of SUBARU OF AMERICA, INC.
  7. Disconnect the connector from EGR valve.
scientia non olet · About LEMON Manuals