Intake Side

WARNING: This page is about a different variant/trim than selected.

Remove the collector cover.
NOTE: Follow these procedures for removal of the collector cover.
1. Lift up the rear side holding two positions (A).
2. Lift up the front side holding two positions (B) while moving it in the forward direction of the vehicle.
  
  Fig 1: Locating Front And Rear Side Holding Position
  Courtesy of SUBARU OF AMERICA, INC.
Disconnect the ground cable from battery.
Remove the securing clips from the two locations on the fuel pipe protector LH.

Fig 2: Locating Fuel Pipe Protector LH Clips
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the PCV hose and blow-by hose.

Fig 3: Locating PCV Hose And Blow-By Hose
Courtesy of SUBARU OF AMERICA, INC.
Remove the fuel pipe protector LH.

Fig 4: Locating Fuel Pipe Protector LH Bolts
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector from intake camshaft position sensor LH.

Fig 5: Identifying Intake Camshaft Position Sensor LH Connector
Courtesy of SUBARU OF AMERICA, INC.
Remove the intake camshaft position sensor LH.

Fig 6: Identifying Intake Camshaft Position Sensor LH
Courtesy of SUBARU OF AMERICA, INC.
Remove the intake camshaft position sensor RH in the same procedure as LH side.