LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Legacy Premium, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Fuel Injection System - Fuel Injection (Fuel Systems) (H6DO - 3.6L DOHC)) >> Camshaft Position Sensor >> Removal >> Exhaust Side

Exhaust Side

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the ground cable from battery.
  2. Lift up the vehicle.
  3. Remove the under cover.
  4. Disconnect the connector from exhaust camshaft position sensor LH.
    Fig 1: Identifying Exhaust Camshaft Position Sensor LH Connector
    G06651244Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the exhaust camshaft position sensor LH.
    Fig 2: Identifying Exhaust Camshaft Position Sensor LH
    G05667585Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the exhaust camshaft position sensor RH in the same procedure as LH side.
scientia non olet · About LEMON Manuals