Fuel Sub Level Sensor: Installation
WARNING: This page is about a different variant/trim than selected.
Install in the reverse order of removal while being careful of the following.
- Make sure the sealing portion is free from fuel or foreign matter before installation.
- Align protrusion (A) of the gasket to the position shown in the figure.
- Align protrusion (B) of the fuel sub level sensor to the cutout in the fuel sub level sensor upper plate.
- After tightening the bolts to the specified torque in the order indicated in the figure, install the fuel sub level sensor protector.
NOTE:
Use a new gasket and retainer.
Tightening torque: 4.4 N.m (0.4 kgf-m, 3.2 ft-lb)