Fuel Pump: Installation
WARNING: This page is about a different variant/trim than selected.
Install in the reverse order of removal while being careful of the following.
- Make sure the sealing portion is free from fuel or foreign matter before installation.
- Align protrusion (A) of the gasket to the position shown in the figure.
- Insert the protrusion (B) of gasket to the fuel pump upper plate. (3 places)
- Align the protrusion (C) of fuel pump assembly with the cutout on the fuel pump upper plate.
- Tighten the nuts to the specified torque in the order as shown in the figure.
- After assembly, install the rubber cap (D) to the position shown in the figure.
NOTE:
- Use a new gasket and retainer.
- Do not forget to install the rubber cap (D).
Tightening torque: 4.4 N.m (0.4 kgf-m, 3.2 ft-lb)