Section 5 (Engine Mechanical (H6DO - 3.6L DOHC)): V-belt: Removal

WARNING: This page is about a different variant/trim than selected.

NOTE: When replacing the single part, perform the work with the engine installed to body.

Remove the collector cover.
NOTE: Follow these procedures for removal of the collector cover.
1. Lift up the rear side holding two positions (A).
2. Lift up the front side holding two positions (B) while moving it in the forward direction of the vehicle.
Fig 1: Locating Front And Rear Side Holding Position
Courtesy of SUBARU OF AMERICA, INC.
Remove the air intake duct. Ref. to REMOVAL , Air Intake Duct.
Install the tool to the pulley bolt of the belt tension adjuster assembly.
Rotate the tool clockwise and loosen the V-belt to remove.

Fig 2: Loosening V-Belt
Courtesy of SUBARU OF AMERICA, INC.