LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Legacy Premium, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Mechanical (H4DOTC - 2.5L DOHC Turbo)) >> Timing Belt Cover >> Removal >> Work On The Engine Unit Only

Work On The Engine Unit Only

WARNING: This page is about a different variant/trim than selected.
  1. Remove the crank pulley. Ref. to REMOVAL , Crank Pulley.
  2. Remove the blow-by pipe from the intake manifold protector RH.
    Fig 1: Locating Blow-By Pipe Bolt
    G06649332Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the vacuum hose (A), vacuum hose (B), vacuum hose (C) and vacuum hose (D) from the clip (E).
    Fig 2: Identifying Vacuum Hose And Clip
    G06649333Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the clip which holds the engine harness to the hose clip stay assembly.
    Fig 3: Identifying Hose Clip Stay Assembly
    G06649334Courtesy of SUBARU OF AMERICA, INC.
  5. Remove timing belt cover RH (B) together with the hose clip stay assembly (A).
  6. Remove timing belt cover (LH) (D) together with the oxygen (A/F) sensor bracket (C).
  7. Remove front timing belt cover (E).
    Fig 4: Identifying Front Timing Belt Cover
    G06649335Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals