Engine Mounting: Installation

WARNING: This page is about a different variant/trim than selected.

Set the engine mounting, and tighten the bolts which hold engine mounting to the engine.
Tightening torque:

58 N.m (5.9 kgf-m, 42.8 ft-lb)

Fig 1: Locating Bolts And Engine Mounting
Courtesy of SUBARU OF AMERICA, INC.
Lower the vehicle.
CAUTION: When lifting down the vehicle, lower wire ropes at the same time.
Attach the bolts and nuts which secure engine mounting to the cradle.
Tightening torque:

60 N.m (6.1 kgf-m, 44.3 ft-lb)

Fig 2: Locating Bolt And Engine Mounting Nuts
Courtesy of SUBARU OF AMERICA, INC.
Install the stopper rod.
Tightening torque:

36 N.m (3.7 kgf-m, 26.6 ft-lb)

Fig 3: Identifying Stopper Rod
Courtesy of SUBARU OF AMERICA, INC.
Remove the lifting device and wire ropes.

Fig 4: Supporting Engine With Lifting Device And Wire Ropes
Courtesy of SUBARU OF AMERICA, INC.
Lift up the vehicle.
Install the front exhaust pipe. Ref. to INSTALLATION , Front Exhaust Pipe.
Install the under cover. Ref. to INSTALLATION , Front Under Cover.
Lower the vehicle.
Install the radiator main fan motor assembly and radiator sub fan motor assembly. Ref. to INSTALLATION , Radiator Main Fan and Fan Motor. Ref. to INSTALLATION , Radiator Sub Fan and Fan Motor.
Install the intercooler. Ref. to INSTALLATION , Intercooler.
Connect the ground cable to battery.

Fig 5: Connecting Ground Cable To Battery
Courtesy of SUBARU OF AMERICA, INC.
Install the collector cover.
Change the front hood damper mounting position from (B) to (A), and close the front hood.
Tightening torque:

20 N.m (2.0 kgf-m, 14.8 ft-lb)

Fig 6: Identifying Front Hood Damper Mounting Position
Courtesy of SUBARU OF AMERICA, INC.