LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Legacy Premium, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Ignition System - Ignition (H6DO - 3.6L DOHC)) >> Spark Plug >> Removal >> LH Side

LH Side

WARNING: This page is about a different variant/trim than selected.
  1. Remove the collector cover.
    NOTE: Follow the steps below when removing the collector cover.
    1. Lift up (A) in two positions at the rear.
    2. Moving (B) in two positions at the front toward the vehicle, lift them up.
      Fig 1: Removing Collector Cover - LH Side
      G06651504Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the battery and battery carrier. Ref. to REMOVAL , Battery.
  3. Remove the bracket (A).
  4. Disconnect the connector (B) from ignition coil.
    Fig 2: Identifying Bracket And Ignition Coil Connector
    G05668091Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the ignition coil.
    NOTE: Turn the #6 ignition coil to remove it.
  6. Remove the spark plug with a spark plug socket.
    Fig 3: Removing Spark Plug With Spark Plug Socket
    G05018962Courtesy of SUBARU OF AMERICA, INC.
    Fig 4: Identifying Spark Plug Socket And Extension Bar
    G06651583Courtesy of SUBARU OF AMERICA, INC.