4-inch Diagnosis
WARNING: This page is about a different variant/trim than selected.
ENABLE CONDITIONS
| Secondary Parameters | Enable Conditions |
|---|---|
| Battery voltage | ≥ 10.9 V |
| Atmospheric pressure | ≥ 75 kPa (563 mmHg, 22.2 inHg) |
| Total time of canister purge operation | ≥ 120000 ms |
| Learning value of evaporation gas density | <0.08 |
| Engine speed | 1050 RPM - 4000 RPM |
| Fuel tank pressure | ≥ -4 kPa (-30 mmHg, -1.2 inHg) |
| Intake manifold relative vacuum (relative pressure) | ≥ -13.3 kPa (-100 mmHg, -3.9 inHg) |
| Continuous time of the status where fuel level is 10.5 l (2.77 US gal, 2.31 lmp gal) - 59.5 l (15.72 US gal, 13.09 lmp gal) | ≥ 37000 ms |
| Closed air/fuel ratio control | In operation |
| Fuel temperature | -10 °C (14 °F) - 45 °C (113 °F) |
| Intake air temperature | ≥ -10°C(14°F) |
| Pressure variation every one second | < 1.7 mmHg (Mode A) < 1.7 mmHg (Mode D) |
| Minimum pressure variation value every one | < 1.7 mmHg (Mode A) |
| second - Maximum pressure variation value every one second | < 1.7 mmHg (Mode D) |
| Fuel level variation every 128 ms | < Value of Map 6 |
| Air fuel ratio | 0.76 - 1.25 |
| Elapsed time after starting the engine | ≥ 851s |
| or | |
| Elapsed time after starting the engine | ≥ 335 s and Vehicle speed 72 km/h (44.7 MPH) or more |
Map 6
FUEL LEVEL POSITION
| Fuel level (l , US gal, lmp gal) | 10,2.64, 2.2 | 20, 5.28, 4.4 | 25,6.61, 5.5 | 30, 7.93, 6.6 | 43,11.36, 9.46 | 45,11.89, 9.9 | 50,13.21, 11 | 60,15.85, 13.2 |
| Change (l , US gal, lmp gal) | 4,1.06, 0.88 | 5,1.32, 1.1 | 6.5,1.72, 1.43 | 4,1.06, 0.88 | 5, 1.32, 1.1 | 5, 1.32, 1.1 | 6,1.59, 1.32 | 8,2.11, 1.76 |