Enable Condition
WARNING: This page is about a different variant/trim than selected.
ENABLE CONDITION
| Secondary Parameters | Enable Conditions |
|---|---|
| All secondary parameters enable conditions | ≥ 1024 ms |
| 120° Intake manifold pressure change at CA | < Value of Map 1 |
| Throttle position variation for 16 ms | <20° |
| Fuel shut-off function | Not in operation |
| Fuel level | ≥ 10.5 l (2.77 US gal, 2.31 lmp gal) |
| Vehicle dynamic control or AT torque control | Not in operation |
| Evaporative system leak check | Not in operation |
| Engine speed | 450 RPM - 6500 RPM |
| Intake manifold pressure | ≥ Value from Map 2 |
| Battery voltage | ≥ 8V |
| Fuel parameter determination | Not extremely low volatility |
| Elapsed time after starting the engine | ≥ 0 ms |
| Engine speed variation for 32 ms | < 500 RPM |
Map 1
ENGINE SPEED REFERENCE
| RPM | 700 | 1000 | 1500 | 2000 | 2500 | 3000 | 3500 | 4000 | 4500 | 5000 | 5500 | 6000 | 6500 | 7000 |
| kPa (mmHg, inHg) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) | 20 (150, 5.9) |
Map 2
ENGINE SPEED REFERENCE
| RPM | 700 | 1000 | 1500 | 2000 | 2500 | 3000 | 3500 | 4000 | 4500 | 5000 | 5500 | 6000 | 6500 | 7000 |
| kPa (mmHg, inHg) | 30.3 (227.6, 9) | 28 (209.9, 8.3) | 25.9 (194.0, 7.6) | 27.7 (207.8, 8.2) | 25.4 (190.2, 7.5) | 27 (202.9, 8) | 29 (217.9, 8.6) | 28.3 (212.5, 8.4) | 28.7 (215.3, 8.5) | 30.6 (229.3, 9) | 32.4 (243.3, 9.6) | 34.3 (257.3, 10.1) | 36.4 (273.3, 10.8) | 36.4 (273.3, 10.8) |