PCV Hose Assembly: Installation

WARNING: This page is about a different variant/trim than selected.

Install the PCV hose assembly to the cylinder block RH and blow-by pipe assembly and connect the vacuum hose to the intake manifold.
NOTE: Use a new clamp for the PCV hose assembly, fit the cut out in the ST with the protrusion on the clamp as shown in the figure, and lock the clamp.

ST 18353AA000 CLAMP PLIERS

Fig 1: Identifying Clamp Pliers ST (18353AA000)
Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Identifying PCV Hose
Courtesy of SUBARU OF AMERICA, INC.
Install the intercooler. Ref. to INSTALLATION , Intercooler.
Install the collector cover.