Section 18 (Emission Control Systems (Aux. Emission Control Devices) (H4DOTC - 2.5L DOHC Turbo)): Canister: Removal

WARNING: This page is about a different variant/trim than selected.

Remove the rear wheel LH.
Lift up the vehicle.
Remove the rear mud guard LH. Ref. to REMOVAL , Mud Guard.
Disconnect the quick connectors of the vent tube (A), canister drain tube (B), charge tube (C) and PCV drain tube (D), and remove the tubes from clips (E).
NOTE: Disconnect the quick connector as shown in the figure.

Fig 1: Identifying Canister
Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Identifying Vent Tube, Canister Drain Tube, Charge Tube And PCV Drain Tube
Courtesy of SUBARU OF AMERICA, INC.
Remove the clip holding the rear wiring harness.

Fig 3: Locating Clip Holding And Rear Wiring Harness
Courtesy of SUBARU OF AMERICA, INC.
Remove the canister from vehicle.

Fig 4: Locating Canister From Vehicle
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the connector from drain valve.

Fig 5: Locating Connector Location
Courtesy of SUBARU OF AMERICA, INC.
Disconnect the vent tube (A), canister drain tube (B), charge tube (C) and PCV drain tube (D) from canister, and remove the canister drain tube ad PCV drain tube (D) from clip (E).
NOTE: Connect the quick connector as shown in the figure.

Fig 6: Identifying Canister
Courtesy of SUBARU OF AMERICA, INC.

Fig 7: Identifying Vent Tube, Canister Drain Tube, Charge Tube And PCV Drain Tube
Courtesy of SUBARU OF AMERICA, INC.