Section 18 (Emission Control Systems (Aux. Emission Control Devices) (H4DOTC - 2.5L DOHC Turbo)): Canister: Installation

WARNING: This page is about a different variant/trim than selected.

Connect the vent tube (A), canister drain tube (B), charge tube (C) and PCV drain tube (D) to canister, and install the canister drain tube (B) and PCV drain tube (D) to clips (E).
CAUTION:
- Make sure there are no damage or dust on connections. If necessary, clean the seal surface of the pipe.
- Make sure that the quick connector is securely connected.
NOTE: Connect the quick connector as shown in the figure.

Fig 1: Connecting Quick Connector
Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Identifying Vent Tube, Canister Drain Tube, Charge Tube And PCV Drain Tube
Courtesy of SUBARU OF AMERICA, INC.
Connect the connector to the drain valve.

Fig 3: Locating Connector Location
Courtesy of SUBARU OF AMERICA, INC.
Install the canister to the vehicle.
Tightening torque:

8 N.m (0.8 kgf-m, 5.9 ft-lb)

Fig 4: Locating Canister From Vehicle
Courtesy of SUBARU OF AMERICA, INC.
Secure the rear wiring harness with clip.

Fig 5: Locating Clip Holding And Rear Wiring Harness
Courtesy of SUBARU OF AMERICA, INC.
Attach all tubes to clips (E), and connect the quick connectors of the vent tube (A), canister drain tube (B), charge tube (C) and PCV drain tube (D).
CAUTION:
- Make sure there are no damage or dust on connections. If necessary, clean the seal surface of the pipe.
- Make sure that the quick connector is securely connected.
NOTE: Connect the quick connector as shown in the figure.

Fig 6: Identifying Quick Connector
Courtesy of SUBARU OF AMERICA, INC.

Fig 7: Identifying Vent Tube, Canister Drain Tube, Charge Tube And PCV Drain Tube
Courtesy of SUBARU OF AMERICA, INC.
Install the rear mud guard LH. Ref. to INSTALLATION , Mud Guard.
Lower the vehicle.
Install the rear wheel LH.
Tightening torque:

120 N.m (12.2 kgf-m, 88.5 ft-lb)