DTC P0965 Forward & Reverse Solenoid Function: Trouble Symptom

WARNING: This page is about a different variant/trim than selected.

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK TRANSMISSION FLUID. Check the condition of ATF. Ref. to CONDITION CHECK , CVTF.	Is the ATF OK?	Go to step 2 .	Check according to the "corrective action" of ATF (CVTF) "CONDITION CHECK". Ref. to CONDITION CHECK , CVTF.
2 CHECK TRANSMISSION FLUID. Check the amount of ATF. Ref. to ADJUSTMENT , CVTF.	Is the ATF amount correct?	Go to step 3 .	Adjust the amount of ATF. Ref. to ADJUSTMENT , CVTF.
3 CHECK INPUT SIGNAL FOR TCM. Start the engine. Warm up until the ATF temperature reaches to 40 - 70°C (104 - 158°F). Shift the select lever to "P" range. Stabilize the engine speed at idle. Read the data of "Actual secondary pressure" using Subaru Select Monitor.	Is "Actual secondary pressure" 0.5 - 1.5 MPa?	Go to step 4 .	Perform the diagnosis according to DTC P0841 procedure.
4 STALL TEST. Perform the stall test. Ref. to STALL TEST .	Is the stall test normal?	Go to step 5 .	If the engine speed increases abruptly, replace the transmission assembly. Ref. to AUTOMATIC TRANSMISSION ASSEMBLY .
5 DRIVING CHECK BY INSPECTION MODE. Turn the ignition switch to OFF. Perform a drive check based on the "Inspection Mode". Ref. to INSPECTION MODE .	Does the AT OIL TEMP light blink and is DTC P0965 displayed?	Replace the transmission assembly. Ref. to AUTOMATIC TRANSMISSION ASSEMBLY .	If there is abrupt increase of engine speed, standing start problems, replace the transmission assembly. Ref. to AUTOMATIC TRANSMISSION ASSEMBLY . If it is normal, temporary poor contact occurs.