Drive Cycle H
WARNING: This page is about a different variant/trim than selected.
DTC CHART
| DTC | Item | Condition |
|---|---|---|
| *P1602 | Control Module Programming Error | - |
Diagnostic procedure:
- Perform the Clear Memory Mode. Ref. to CLEAR MEMORY MODE .
- With the ignition switch ON (engine OFF), read the engine coolant temperature, intake air temperature and fuel temperature. Ref. to READ CURRENT DATA FOR ENGINE (NORMAL MODE) , OPERATION, Subaru Select Monitor.
- If the values from step 2) satisfy the following two conditions, idle the engine for one minute.
Condition:
| Engine coolant temperature - Intake air temperature | ≤ 5°C (41 °F)
| Engine coolant temperature - Fuel temperature | ≤ 2°C (36°F)
NOTE:
- If the conditions are not satisfied, turn the ignition switch to OFF and wait until the parameters are satisfied.
- Hold the select lever in "P" range or "N" range at idling.