LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Legacy Premium, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Controls - Engine (Diagnostics) (H6DO - 3.6L DOHC)) >> Drive Cycle >> Procedure >> Drive Cycle E

Drive Cycle E

WARNING: This page is about a different variant/trim than selected.
DTC CHART

DTC Item Condition
*P0461 Fuel Level Sensor "A" Circuit Range/Performance -

Diagnostic procedure: 

  1. Make sure that the battery voltage is 10.9 V or more.
  2. Perform the Clear Memory Mode. Ref. to CLEAR MEMORY MODE .
  3. Drive the vehicle for the distance equal to the fuel of 30 (7.9 US gal, 6.6 lmp gal).
NOTE:
  • It is acceptable to drive the vehicle intermittently.
  • Do not disconnect the battery terminals while diagnosing. (Data will be cleared by disconnecting the battery terminals.)