Drive Cycle D
WARNING: This page is about a different variant/trim than selected.
DTC CHART
| DTC | Item | Condition |
|---|---|---|
| *P0181 | Fuel Temperature Sensor "A" Circuit Range/Performance | - |
NOTE:
In drive cycle D, one drive cycle will be established when both the drift diagnosis and stuck diagnosis have completed.
Diagnostic procedure:
DRIFT DIAGNOSIS
- Make sure of the items below before starting the engine.
- Engine coolant temperature is less than 30°C (86°F).
- Remaining fuel is 10 fi (2.6 US gal, 2.2 lmp gal) or more.
- Battery voltage is 10.9 V or more.
- Idle the engine until engine coolant temperature is at least 10°C (18°F) higher than it was when engine started.
- After the engine has reached the state of procedure 2), idle the engine for another 5 minutes or more.
STUCK DIAGNOSIS
- Make sure that the battery voltage is 10.9 V or more.
- Perform the Clear Memory Mode. Ref. to CLEAR MEMORY MODE .
- Drive the vehicle for the distance equal to the fuel of 50 0 (13.2 US gal, 11 lmp gal).
NOTE:
- It is acceptable to drive the vehicle intermittently.
- Do not disconnect the battery terminals during stuck diagnosis. (Data will be cleared by disconnecting the battery terminals.)