DTC P2420 Evaporative Emission System Switching Valve Control Circuit High: Wiring Diagram

WARNING: This page is about a different variant/trim than selected.

Fig 1: Evaporative Emission Control System - Wiring Diagram

G06647806

Courtesy of SUBARU OF AMERICA, INC.

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK HARNESS BETWEEN ECM AND PURGE CONTROL SOLENOID VALVE 2 CONNECTOR. Turn the ignition switch to OFF. Disconnect the connectors from ECM and purge control solenoid valve 2. Turn the ignition switch to ON. Measure the voltage between ECM and chassis ground. Connector & terminal (B137) No. 15 (+) - Chassis ground (-):	Is the voltage 10 V or more?	Repair the short to power in the harness between ECM and purge control solenoid valve 2 connector.	Go to step 2 .
2 CHECK PURGE CONTROL SOLENOID VALVE 2. Turn the ignition switch to OFF. Measure the resistance between purge control solenoid valve 2 terminals. Terminals No. 1 - No. 2:	Is the resistance less than 1 Ω	Replace the purge control solenoid valve 2. Ref. to PURGE CONTROL SOLENOID VALVE .	Repair the poor contact of ECM connector.