LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Legacy Premium, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Engine Controls - Engine (Diagnostics) (H4DOTC - 2.5L DOHC Turbo)) >> Diagnostic Procedure with Diagnostic Trouble Code (DTC) >> DTC P0068 Map/MAF - Throttle Position Correlation >> Wiring Diagram

DTC P0068 Map/MAF - Throttle Position Correlation: Wiring Diagram

WARNING: This page is about a different variant/trim than selected.
Fig 1: MAP/MAF - Throttle Position - Wiring Diagram
G06647760Courtesy of SUBARU OF AMERICA, INC.
DIAGNOSTIC PROCEDURE

Step Check Yes No
1 CHECK AIR INTAKE SYSTEM  . Are there holes, loose bolts or disconnection of hose on air intake system? Repair the air intake system. Go to step .
2 CHECK MANIFOLD ABSOLUTE PRESSURE SENSOR  .
  1. Start the engine and warm up engine until coolant temperature is higher than 75°C (167°F).
  2. Place the shift lever in neutral position.
  3. Turn the A/C switch to OFF.
  4. Turn all the accessory switches to OFF.
  5. Read the data of intake manifold pressure sensor signal using Subaru Select Monitor or general scan tool.
NOTE:
  • Subaru Select Monitor

    For detailed operation procedures, refer to "READ CURRENT DATA FOR ENGINE". Ref. to SUBARU SELECT MONITOR .

  • General scan tool

    For detailed operation procedures, refer to the General Scan Tool Instruction Manual.

Is the measured value 73.3 - 106.6 kPa (550 - 800 mmHg, 21.65 - 31.50 inHg) when the ignition is turned ON, and 20.0 - 46.7 kPa (150-350 mmHg, 5.91 -13.78 inHg) during idling? Go to step . Replace the manifold absolute pressure sensor. Ref. to MANIFOLD ABSOLUTE PRESSURE SENSOR .
3 CHECK THROTTLE OPENING ANGLE  .
Read the data of throttle position signal using Subaru Select Monitor or general scan tool.
NOTE:
  • Subaru Select Monitor

    For detailed operation procedures, refer to "READ CURRENT DATA FOR ENGINE". Ref. to SUBARU SELECT MONITOR .

  • General scan tool

    For detailed operation procedures, refer to the General Scan Tool Instruction Manual.

Is the measured value less than 5% when throttle is fully closed? Go to step . Replace the electronic throttle control. Ref. to THROTTLE BODY .
4 CHECK THROTTLE OPENING ANGLE  . Is the measured value 85% or more when throttle is fully open? Replace the manifold absolute pressure sensor. Ref. to MANIFOLD ABSOLUTE PRESSURE SENSOR . Replace the electronic throttle control. Ref. to THROTTLE BODY .