Center Exhaust Pipe: Installation

WARNING: This page is about a different variant/trim than selected.

Set the center exhaust pipe (front) together with turbocharger upper stay (A), and install stud bolts to the turbocharger by using the TORX® socket E10.
NOTE: Use a new gasket.

Tightening torque:

14.7 N.m (1.5 kgf-m, 10.8 It-lb)

Fig 1: Locating Bolts And Turbocharger
Courtesy of SUBARU OF AMERICA, INC.
Install the center exhaust pipe (front) to the turbocharger together with turbocharger upper stay (A) and turbocharger lower stay (B).
NOTE: Use a new self-locking nut.

Tightening torque:

42.5 N.m (4.3 kgf-m, 31.3 ft-lb)

Fig 2: Locating Center Exhaust Pipe (Front)
Courtesy of SUBARU OF AMERICA, INC.
Install bolts which hold the oil catch tank stay and engine cover to the turbocharger lower stay.
Tightening torque:

6.4 N.m (0.7 kgf-m, 4.7 ft-lb)

Fig 3: Locating Bolts And Oil Catch Tank Stay
Courtesy of SUBARU OF AMERICA, INC.
Attach the bolt which holds the turbocharger stay.
Tightening torque:

33 N.m (3.4 kgf-m, 24.3 ft-lb)

Fig 4: Locating Bolts And Turbocharger Stay
Courtesy of SUBARU OF AMERICA, INC.
Install the center exhaust pipe (rear) and temporarily tighten the bolt which holds center exhaust pipe (rear) to the hanger bracket.

Fig 5: Locating Center Exhaust Pipe (Rear) Bolt
Courtesy of SUBARU OF AMERICA, INC.
Install the rear exhaust pipe to the center exhaust pipe (rear).
NOTE: Use a new gasket.

Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)

Fig 6: Locating Rear Exhaust Pipe
Courtesy of SUBARU OF AMERICA, INC.
Install the center exhaust pipe (front) to the center exhaust pipe (rear).
NOTE: Use a new gasket.

Tightening torque:

42.5 N.m (4.3 kgf-m, 31.3 ft-lb)

Fig 7: Locating Center Exhaust Pipe (Rear) Bolts
Courtesy of SUBARU OF AMERICA, INC.
Tighten the bolts which hold center exhaust pipe (rear) to the hanger bracket.
Tightening torque:

35 N.m (3.6 kgf-m, 25.8 ft-lb)

Fig 8: Locating Center Exhaust Pipe (Rear) Bolt
Courtesy of SUBARU OF AMERICA, INC.
Install the under cover. Ref. to INSTALLATION , Front Under Cover.
Lower the vehicle.
Connect connectors to the front oxygen (A/F) sensor and rear oxygen sensor, and secure the front oxygen (A/F) sensor harness and rear oxygen sensor harness with the clip (A).

Fig 9: Identifying Front Oxygen (A/F) Sensor Harness And Rear Oxygen Sensor Harness
Courtesy of SUBARU OF AMERICA, INC.
Connect the ground cable to battery.

Fig 10: Connecting Ground Cable To Battery
Courtesy of SUBARU OF AMERICA, INC.
Install the collector cover.