LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Legacy Premium, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Continuously Variable Transmission) >> Transfer Clutch >> Removal

Transfer Clutch: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission assembly from the vehicle. Ref. to REMOVAL , Automatic Transmission Assembly.
  2. Remove the extension case. Ref. to REMOVAL , Extension Case.
  3. Remove the rear drive shaft. Ref. to REMOVAL , Rear Drive Shaft.
  4. Remove the thrust needle bearing and needle bearing.
    Fig 1: Identifying Thrust Needle Bearing And Needle Bearing
    G06654510Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the transfer clutch assembly.
    Fig 2: Identifying Transfer Clutch Assembly
    G06654511Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the seal ring from transfer clutch assembly.
    Fig 3: Locating Seal Ring
    G06654512Courtesy of SUBARU OF AMERICA, INC.