Transmission Rear CROSSMEMBER & Rear Cushion Rubber

WARNING: This page is about a different variant/trim than selected.

Install the rear cushion rubber.
Tightening torque:

T1:35 N.m (3.6 kgf-m, 25.8 ft-lb)

T2:40 N.m (4.1 kgf-m, 29.5 ft-lb)

Fig 1: Identifying Rear Crossmember And Cushion Rubber
Courtesy of SUBARU OF AMERICA, INC.
Install the crossmember.
Tightening torque:

75 N.m (7.6 kgf-m, 55.3 ft-lb)

Fig 2: Locating Rear Crossmember
Courtesy of SUBARU OF AMERICA, INC.
Remove the transmission jack.
Install the heat shield cover. Ref. to INSTALLATION , Heat Shield Cover.
Install the front exhaust pipe. Ref. to INSTALLATION , Front Exhaust Pipe.
Install the under cover. Ref. to INSTALLATION , Front Under Cover.
Lower the vehicle.
Connect the ground cable to battery.