LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2010 >> Legacy Premium, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Automatic Transmission) >> Oil Pump Cover >> Installation

Oil Pump Cover: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Secure the oil pump cover.

    Tightening torque: 

    41 N.m (4.2 kgf-m, 30.2 ft-lb) 

    Fig 1: Identifying Oil Pump Cover Mounting Bolt
    G05022338Courtesy of SUBARU OF AMERICA, INC.
  2. Install the converter case assembly to the transmission case assembly. Ref. to INSTALLATION , Torque Converter Assembly.
  3. Install the transmission harness connector to the stay.
  4. Install the ATF cooler pipe. Ref. to INSTALLATION , ATF Cooler Pipe and Hose.
  5. Install the torque converter assembly. Ref. to INSTALLATION , Torque Converter Assembly.
  6. Install the transmission assembly to the vehicle. Ref. to INSTALLATION , Automatic Transmission Assembly.
scientia non olet · About LEMON Manuals