Radiator Main Fan and Fan Motor: Installation

WARNING: This page is about a different variant/trim than selected.

Tighten the bolts on the upper side of radiator fan shroud.
Tightening torque: 7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

Fig 1: Locating Upper Side Of Radiator Fan Shroud Bolts
Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Locating Upper Side Of Radiator Fan Shroud Bolts
Courtesy of SUBARU OF AMERICA, INC.
Install radiator upper hoses LH and RH to the radiator.

Fig 3: Locating Radiator Upper Hoses LH And RH
Courtesy of SUBARU OF AMERICA, INC.
Install the reservoir tank. Ref. to INSTALLATION , Reservoir Tank.
Attach the grille bracket.

Fig 4: Locating Grille Bracket Clips
Courtesy of SUBARU OF AMERICA, INC.
Install the air intake duct. Ref. to INSTALLATION , Air Intake Duct.
Lift up the vehicle.
Connect the integrated connector of radiator main fan & fan motor and radiator sub fan & fan motor.

Fig 5: Locating Integrated Connector Of Radiator Main Fan & Fan Motor
Courtesy of SUBARU OF AMERICA, INC.
Install the under cover. Ref. to INSTALLATION , Front Under Cover.
Lower the vehicle.
Fill engine coolant. Ref. to FILLING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant.
Connect the ground cable to battery.
Install the collector cover.