Rear Disc Brake Assembly: Installation

Apply a thin coat of Molykote M7439 (Part No.K0770YA000) or grease contained in the pad kit to the support.

Fig 1: Applying Thin Coat Of Molykote M7439 (Part No. K07470YA000) To Support
Courtesy of SUBARU OF AMERICA, INC.
Install the support to the housing.
Tightening torque:

66 N.m (6.7 kgf-m, 48.7 ft-lb)
Apply a thin coat of Molykote M7439 (Part No.K0770YA000) or grease contained in the pad kit to the pad clip.

Fig 2: Applying Thin Coat Of Molykote M7439 To Pad Clip
Courtesy of SUBARU OF AMERICA, INC.
Apply a thin coat of Molykote AS880N (Part No.K0777YA010) or grease contained in the pad kit to the contact surfaces between pad and shim.

Fig 3: Applying Thin Coat Of Molykote AS880N Between Pad And Shim
Courtesy of SUBARU OF AMERICA, INC.
Apply a thin coat of Molykote AS880N (Part No.K0777YA010) or grease contained in the pad kit to both sides of the pad inner shim.

Fig 4: Applying Thin Coat Of Molykote AS880N To Surfaces Of Pad Inner Shim
Courtesy of SUBARU OF AMERICA, INC.
Install the pad to support.
Install the caliper body to the support.
Tightening torque:

27 N.m (2.8 kgf-m, 19.9 ft-lb)
Connect the brake hose using a new brake hose gasket.
Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)
Bleed air from the brake system.