LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Tribeca Limited >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System - Brakes - Mechanical >> Rear Disc Brake Assembly >> Assembly

Rear Disc Brake Assembly: Assembly

  1. Clean the inside of the caliper body using brake fluid.
  2. Apply a coat of brake fluid to piston seal and install the piston seal to the caliper body groove.
  3. Apply a coat of brake fluid to the inner surface of cylinder and the entire outer surface of the piston.
  4. Apply grease contained in the piston seal kit to the boot, and install it to the groove at the ends of the cylinder.
  5. Insert the piston into cylinder.
    CAUTION: Do not force the piston into cylinder.
  6. Position the boot in the grooves on piston and cylinder.
    Fig 1: Identifying Boot Position In Grooves On Cylinder And Piston
    G06343630Courtesy of SUBARU OF AMERICA, INC.
  7. Apply grease contained in the piston seal kit to the guide pin, outer surface, sleeve outer surface, cylinder inner surface, and boot grooves.
    Fig 2: Identifying Pin Boot And Lock Pin Or Guide Pin
    G06343631Courtesy of SUBARU OF AMERICA, INC.
  8. Insert the guide pin boot to the support.
  9. Insert the lock pin boot to support, and then insert the lock pin sleeve into the specified position.
scientia non olet · About LEMON Manuals