Rear Brake Pad: Inspection

Check the pad thickness A.

Fig 1: Identifying Pad Thickness

Courtesy of SUBARU OF AMERICA, INC.

PAD THICKNESS SPECIFICATION

Pad thickness mm (in)	Standard	11.0 (0.433)
Pad thickness mm (in)	Wear limit	1.5 (0.059)

NOTE:

Always replace the pads of both sides as a set on both wheels.
Replace pad clips if they are twisted or worn.
A wear indicator is installed on the inner disc brake pad. If the pad is worn to the limit, the end of wear indicator contacts disc rotor, and a squeaking sound is heard as the wheel rotates. If the sound is heard, replace the pad.
Replace the pad if there is oil or grease on it.