Front Disc Brake Assembly: Installation

Apply a thin coat of Molykote M7439 (Part No. K0770YA000) or grease contained in the pad kit to the support.

Fig 1: Applying Thin Coat Of Molykote M7439 (Part No. K07470YA000) To Support
Courtesy of SUBARU OF AMERICA, INC.
Install the support to the housing.
Tightening torque:

120 N.m (12.2 kgf-m, 88.5 ft-lb)
Apply a thin coat of Molykote M7439 (Part No. K0770YA000) or grease contained in the pad kit to the pad clip.

Fig 2: Applying Thin Coat Of Molykote M7439 To Pad Clip
Courtesy of SUBARU OF AMERICA, INC.
Apply a thin coat of Molykote AS880N (Part No. K0777YA010) or grease contained in the pad kit to the contact surfaces between pad and inner shim.

Fig 3: Applying Thin Coat Of Molykote AS880N Between Pad And Pad Inner Shim
Courtesy of SUBARU OF AMERICA, INC.
Apply a thin coat of Molykote AS880N (Part No. K0777YA010) or grease contained in the pad kit to the three contact surfaces between inner shim and outer shim of outer pads.

Fig 4: Applying Thin Coat Of Molykote AS880N Between Inner Shim And Outer Shim Of Outer Pads
Courtesy of SUBARU OF AMERICA, INC.
Install the pad to support.
NOTE: Install the pad indicator in proper direction.

Fig 5: Identifying Pad To Support
Courtesy of SUBARU OF AMERICA, INC.
CAUTION:
- Be sure to install so that the pad return spring faces the input side of the direction of brake rotor rotation, as shown in the figure.
- Correctly install the pad return spring to the supporting surface of the pad clip as shown in the figure.
- If the pad return spring is deformed or damaged, replace the brake pad.
  
  Fig 6: Identifying Rotor Rotation Direction
  Courtesy of SUBARU OF AMERICA, INC.
Install the caliper body to the support.
Tightening torque:

27 N.m (2.8 kgf-m, 19.9 ft-lb)
Connect the brake hose using a new brake hose gasket.
Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)
Bleed air from the brake system.