LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Tribeca Limited >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System - Brakes - Mechanical >> Brake Pedal >> Removal

Brake Pedal: Removal

  1. Remove the steering shaft.
  2. Disconnect the connector (stop light switch etc.) from the pedal bracket.
  3. Remove the clevis pin which secures the lever and push rod.
  4. Remove the bolt and nut which secures the pedal bracket.
    Fig 1: Identifying Snap Pin, Clevis Pin And Operating Rod
    G06343659Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals