LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Outback i, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Exhaust System - Exhaust (H4DOTC)) >> Center Exhaust Pipe >> Removal

Center Exhaust Pipe: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION: Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.
  1. Set the vehicle on a lift.
  2. Remove the collector cover.
  3. Disconnect the ground cable from battery.
    Fig 1: Connecting/Disconnecting Ground Cable From Battery
    G05019586Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the intercooler. Ref. to REMOVAL , Intercooler.
  5. Lift up the vehicle.
  6. Remove the bolts which hold the lower side of the turbocharger lower cover.
    Fig 2: Locating Turbocharger Lower Cover Bolts
    G06335618Courtesy of SUBARU OF AMERICA, INC.
  7. Lower the vehicle.
  8. Remove the turbocharger upper cover.
    Fig 3: Identifying Turbocharger Upper Cover
    G05660706Courtesy of SUBARU OF AMERICA, INC.
  9. Remove the bolts which secure the upper side of the turbocharger lower cover.
    Fig 4: Locating Upper Side Of Turbocharger Lower Cover Bolt
    G05955332Courtesy of SUBARU OF AMERICA, INC.
  10. Remove the upper side bolts and nuts that hold the center exhaust pipe on the turbocharger, and remove the turbocharger cover stay (A).
    Fig 5: Locating Turbocharger Cover Stay Bolts And Nuts
    G06335621Courtesy of SUBARU OF AMERICA, INC.
  11. Lift up the vehicle.
  12. Remove the lower side nuts (two places) that hold the center exhaust pipe on the turbocharger.
    Fig 6: Locating Center Exhaust Pipe Nuts
    G05955334Courtesy of SUBARU OF AMERICA, INC.
  13. Remove clip (A) holding the rear oxygen sensor harness. (AT model)
  14. Disconnect the connector from rear oxygen sensor.
    • AT model
      Fig 7: Identifying Rear Oxygen Sensor Connector - AT Model
      G06335123Courtesy of SUBARU OF AMERICA, INC.
    • MT model
      Fig 8: Identifying Rear Oxygen Sensor Connector - MT Model
      G06335124Courtesy of SUBARU OF AMERICA, INC.
  15. Separate the center exhaust pipe from rear exhaust pipe.
    Fig 9: Locating Center Exhaust Pipe Bolts
    G05018834Courtesy of SUBARU OF AMERICA, INC.
  16. Remove the bolt which holds center exhaust pipe bracket to transmission.
    Fig 10: Locating Center Exhaust Pipe Bracket Bolt
    G05661009Courtesy of SUBARU OF AMERICA, INC.
  17. Remove the bolt which holds center exhaust pipe to hanger bracket, and remove the center exhaust pipe.
    CAUTION: Be careful not to drop the center exhaust pipe.
    Fig 11: Locating Center Exhaust Pipe Bolts
    G05018255Courtesy of SUBARU OF AMERICA, INC.
  18. Remove the turbocharger lower cover.
  19. Separate the center exhaust pipe (front) and center exhaust pipe (rear).
    Fig 12: Identifying Center Exhaust Pipe (Front) And Center Exhaust Pipe (Rear)
    G05661011Courtesy of SUBARU OF AMERICA, INC.