DTC Display Mode

It is possible to display the DTC of the combination meter through the following procedures.

1. Within 3 seconds after turning the ignition switch to ON, set the lighting switch to tail light or headlight position.
2. Press the ODO/trip meter knob four times.
3. Turn the lighting switch to OFF, and press the ODO/trip meter knob four times.
4. Set the lighting switch to tail light or headlight position again, and press the ODO/tripmeter knob four times.
   NOTE:

   • Perform the steps described in  2) and  4) within 10 seconds.
   • When the engine starts during diagnosis, the self-diagnosis function is not cancelled, however, once turning the ignition switch to OFF or the vehicle starts driving, DTC display mode is cancelled automatically for safety.
   • When the DTC display mode operates, {ECM}, {TCM}, {ABS/VDC} is displayed cyclically in this order for every three seconds or every press of the trip knob. DTC is displayed in the following table according to type of control module, receiving DTC, DTC detected, No DTC.
   • Past problems are displayed on the DTC display. When the DTC of individual control modules changes in status from current trouble to past trouble, and the trouble is fixed, the DTC will no longer appear in the combination meter if the engine is started three times or more.
   • Normal meter
     CONTROL MODULE CONDITION CHART
     
     

     Control module	Condition	Display
     ECM	Receiving DTC	Trip "A" + "P (Blink)"
     	DTC detected	Trip "A" + "P xxxx"
     	No DTC	Trip "A" + "P -"
     TCM	Receiving DTC	Trip "B" + "P (Blink)"
     	DTC detected	Trip "B" + "P xxxx"
     	No DTC	Trip "B" + "P -"
     ABS/VDCCM	Receiving DTC	Trip "A" + "C (Blink)"
     	DTC detected	Trip "A" + "C xxxx"
     	No DTC	Trip "A" + "C -"
     When CAN communication error is occurred	-	"-"

   • Meter with multi-information display
     MULTI-INFORMATION DISPLAY CHART
     
     

     Control module	Multi screen		Condition	Multi display
     ECM	EG I fail code	Pxxxx	Receiving DTC	"P" blinking
     			DTC detected	"P xxxx"
     			No DTC	"P -"
     TCM	TCM fail code	P xxxx	Receiving DTC	"P" blinking
     			DTC detected	"P xxxx"
     			No DTC	"P -"
     ABS/VDCCM	ABS fail code	P xxxx	Receiving DTC	"C" blinking
     			DTC detected	"C xxxx"
     			No DTC	"C -"
     When CAN communication error is occurred	Body CAN fail	-	-	-

     NOTE: Because the MT model is not equipped with a TCM, only "Receiving DTC" is displayed.