Read Diagnostic Trouble Code (DTC)

NOTE:

DTC is displayed in the sequence of inputting. (When entering two DTCs or more simultaneously, they are displayed in the sequence of priority.)
When more than one DTC is displayed, perform the diagnosis of top one.

Prepare the Subaru Select Monitor kit.
Connect the diagnosis cable to Subaru Select Monitor.
Connect the Subaru Select Monitor to data link connector.
Data link connector is located in the lower portion of instrument panel (on the driver's side).

Fig 1: Locating Data Link Connector
Courtesy of SUBARU OF AMERICA, INC.

CAUTION: Do not connect scan tools other than the Subaru Select Monitor.
Turn the ignition switch to ON (engine OFF) and run the Subaru Select Monitor.
On the «Main Menu» display, select the {Each System Check}.
On the «System Selection Menu» display, select the {Integ. unit mode}.
On the «Integ. unit mode failure diag» display, select the {Diagnostic Code(s) Display}.
NOTE:
- For details concerning the operation procedure, refer to Subaru Select Monitor .
- For details concerning DTCs, refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .