LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Outback i, Standard >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Accessory Drive Belts >> Engine Mechanical (H4SO) >> V-belt >> Installation >> Rear Side Belt

Rear Side Belt

CAUTION:
  • When reusing the rear side belt, wipe off dust and water with cloth.
  • Do not use the rear side belt if there is any oil, grease or coolant on the belt.
  • Be careful not to rub the belt end surface with bare hands; exposed core may cause injury.
  1. Wipe off any dust, oil and water on the groove of each pulley with cloth.
  2. Install the belt tensioner.
  3. Install the rear side belt, and adjust the slider bolt (B) so as to obtain the specified belt tension. Refer to INSPECTION , V-belt.
  4. Tighten the lock nut (A).

    Tightening torque: 

    Lock nut (A) 23 N.m (2.3 kgf-m, 17.0 ft-lb) 

    Fig 1: Identifying Lock Nut And Slider Bolt
    G04997630Courtesy of SUBARU OF AMERICA, INC.
  5. Install the front side belt. Refer to FRONT SIDE BELT , INSTALLATION, V-belt.
scientia non olet · About LEMON Manuals