LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Outback i, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Brake System - Brakes - Mechanical >> Stop Light Switch >> Inspection >> Check Resistance

Check Resistance

  1. If the stop light switch does not operate properly, replace with a new part.
  2. Measure the resistance of stop light switch terminals.
    Fig 1: Measuring Resistance Of Stop Light Switch Terminals
    G05671326Courtesy of SUBARU OF AMERICA, INC.
    STOP LIGHT SWITCH REFERENCE

    Pedal Terminal No. Standard value
    Released 1 and 4 Less than 1 Ω
    2 and 3 1 MΩ or more
    Depressed 1 and 4 1 MΩ or more
    2 and 3 Less than 1 Ω
scientia non olet · About LEMON Manuals