Brake Pipe: Installation
NOTE:
The airbag system wiring harness is routed near the center brake pipe.
CAUTION:
- All airbag system wiring harness and connectors are colored yellow. Do not use electrical test equipment on these circuits.
- Be careful not to damage the airbag system wiring harness when servicing the center brake pipe.
- When installing the brake pipe, do not bend.
- After installing the brake pipe and hose, perform air bleed.
- After installing the brake hoses, make sure that they do not contact the tires or suspension assembly, etc.
Brake pipe tightening torque:
Refer to FRONT BRAKE PIPES AND HOSES , COMPONENT, General Description.
Refer to CENTER AND REAR BRAKE PIPES AND HOSES , COMPONENT, General Description.