Rear Brake Hose

Route the brake hose through the hole of bracket, and lightly tighten the flare nut to connect brake pipe.
Insert the clamp to secure brake hose.

Fig 1: Identifying Clamp And Brake Hose (1 Of 2)
Courtesy of SUBARU OF AMERICA, INC.

Fig 2: Identifying Clamp And Brake Hose (2 Of 2)
Courtesy of SUBARU OF AMERICA, INC.
Install the brake hose to rear brake caliper using a new gasket.
Tightening torque (union bolt):

18 N.m (1.8 kgf-m, 13.0 ft-lb)

Fig 3: Identifying Brake Hose
Courtesy of SUBARU OF AMERICA, INC.
Tighten the flare nut to the specified torque.
Tightening torque (brake pipe flare nut):

15 N.m (1.5 kgf-m, 10.8 ft-lb)
Bleed air from the brake system.