LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Outback i, Standard >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Brake System - Brakes - Mechanical >> Brake Fluid >> Replacement

Brake Fluid: Replacement

CAUTION:
  • Do not let brake fluid come into contact with the painted surface of the vehicle body. Wash away with water immediately and wipe off if it is spilled by accident.
  • Avoid mixing brake fluid of different brands to prevent fluid performance from degrading.
  • Be careful not to allow dirt or dust to enter the reservoir tank.
NOTE:
  • During the operation, keep the reservoir tank filled with brake fluid to eliminate entry of air.
  • Operate the brake pedal slowly.
  • For convenience and safety, two people should do the work.
  • The required amount of brake fluid is approximately 500 ml (16.9 US fl oz.; 17.6 lmp fl oz.) for the entire brake system.
  1. Lift up the vehicle and set rigid racks at the specified locations, or keep the vehicle lifted.
  2. Remove both the front and rear wheels.
  3. Drain brake fluid from the reservoir tank.
  4. Refill the reservoir tank with the recommended brake fluid.

    Recommended brake fluid: 

    Refer to SPECIFICATION .

    Perform the same procedure as for bleeding the brake line, until new brake fluid comes out from vinyl tube. Refer to PROCEDURE , Air Bleeding.

scientia non olet · About LEMON Manuals