LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Outback i, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seat System - Seats >> Front Seat >> Removal >> Passenger's Seat

Passenger's Seat

CAUTION: Refer to "CAUTION" of "General Description" before starting the work. Ref. to CAUTION , General Description.
  1. Remove the headrest.
  2. Tilt the backrest forward, and move the seat forward.
  3. Remove the rear bolt cover, and then remove the rear side of slide rail.
  4. Move the seat backward, remove the front bolt cover, and then remove the bolt at the front side of the slide rail.
  5. Disconnect the ground cable from the battery.
    CAUTION: When remove the battery negative terminal, wait 20 seconds then go to the next procedure.
  6. Disconnect all the connectors of connector holder in the backside of seat cushion.
    • Harness connector of occupant detection control module
    • Side airbag connector
    • Power seat connector (model with power seats)
    • Seat heater connector (model with seat heater)
  7. Remove the seat from vehicle.
scientia non olet · About LEMON Manuals