Rear Wiper Motor

Rear Wiper Motor

REMOVAL

1. Disconnect the ground cable from the battery.
2. Remove the rear wiper arm.
3. Remove the rear gate lower trim.
4. Disconnect the harness connector of wiper motor assembly.
5. Remove the bolts to remove wiper motor assembly (A).






INSTALLATION

1. Install in the reverse order of removal.
2. Be sure that the pivot cap with the arrow mark facing up, as shown in the figure.






REAR WIPER (WAGON MODEL)

Tightening torque: N.m (kgf.m, ft.lb)
T1: 7.5 (0.76, 5.5)
T2: 8.0 (0.82, 5.9)