Front Sub Sensor

Front Sub Sensor

REMOVAL

1. Turn the ignition switch to OFF.
2. Disconnect the ground cable from battery and wait for at least 20 seconds before starting work.
3. Remove the front bumper face.
4. Remove the bolt, and then detach the front sub sensor.






5. Disconnect the connector from front sub sensor.

INSTALLATION

CAUTION:
Do not reuse the bolt and nut.
Always use new bolts and nuts for them.

Install in the reverse order of removal.

Tightening torque: 13 N.m (1.32 kgf.m, 9.6 ft.lb)