Section 8 (Auxiliary Emission Control Devices (H4SO)): Canister: Removal
WARNING: This page is about a different variant/trim than selected.
- Disconnect the ground cable from the battery.
- Open the rear gate, and remove the luggage floor mat.
- Remove the center sub trunk (A) (model with center sub trunk), and remove the sub trunk RH (B) and sub trunk LH (C) fixed by clips.
- Tilt the rear seat backrest forward.
- Remove the clips that is holding the rear seat backrest cover on the canister cover, and turn over the rear seat backrest cover toward the front side of the vehicle.
- Remove the center canister cover.
- Remove the canister cover RH.
- Disconnect the purge tube (A), vent tube (B), drain tube A (C) and PCV drain tube (D).NOTE: Disconnect the quick connector as shown in the figure.
- Remove the canister.
- Remove the canister cover LH.
- Disconnect drain tube A (A) and drain tube B (B).NOTE: Disconnect the quick connector as shown in the figure.
- Disconnect connector (C) from the drain valve, and remove the drain valve.
- Disconnect purge tube (A) and vent tube (B).NOTE: Disconnect the quick connector as shown in the figure.
- Remove purge tube (A), vent tube (B), and drain tube A (C).