LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Forester XT Limited >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Anti-Theft System - Security And Locks >> Ignition Key Lock >> Inspection

Ignition Key Lock: Inspection

  1. Remove the instrument panel lower cover.
  2. Remove the lower column cover.
  3. Unfasten the fixing clip which secures harness, and then disconnect the connector of the ignition switch from body harness.
  4. Turn the ignition key plate to each position and check the continuity between terminals of ignition connector.
Fig 1: Identifying Ignition Switch Connector Terminals
G05022828Courtesy of SUBARU OF AMERICA, INC.
CONNECTOR TERMINALS REFERENCE CHART

Switch position Terminal Standard
LOCK - -
ACC No. 3 and No. 5 Less than 1 Ω
ON No. 3 and No. 1 and No. 4 No. 3 and No. 5 Less than 1 Ω
ST No. 3 and No. 2 No. 3 and No. 1 and No. 6 Less than 1 Ω

If NG, replace the ignition switch.

scientia non olet · About LEMON Manuals