LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2009 >> Forester XT Limited >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> LAN Communication System - LAN (Diagnostics) >> Subaru Select Monitor >> Operation

Subaru Select Monitor: Operation

  1. Prepare the Subaru Select Monitor kit. Refer to PREPARATION TOOL , General Description .
    Fig 1: Identifying Subaru Select Monitor Kit
    G05658482Courtesy of SUBARU OF AMERICA, INC.
  2. Prepare the personal computer which has been installed the Subaru Select Monitor.
  3. Connect the USB cable between SDI (Subaru Diagnosis Interface) and USB port on the personal computer (dedicated port for the Subaru Select Monitor).
    NOTE: The dedicated port for the Subaru Select Monitor means the USB port which was used to install the Subaru Select Monitor.
  4. Connect the diagnosis cable to SDI.
  5. Connect the SDI to data link connector located in the lower portion of the instrument panel (on the driver's side).
    Fig 2: Locating Data Link Connector
    G05663967Courtesy of SUBARU OF AMERICA, INC.
  6. Start a PC.
  7. Turn the ignition switch to ON (engine OFF), and run the "PC application for Subaru Select Monitor".
scientia non olet · About LEMON Manuals